‘Alien’ Bobblehead

So this one… I bought this from a local-ish action figure shop, he had no idea where it came from originally…. and neither do I. The figure itself has no markings, is made from resin, and is numbered but not signed, so I assume this some rando-artist item. 

So here is this piece:

image

From the front, we have something that seems to be a xeno crossed with H R Giger’s original art. The base appears to be based on an Alien egg, though this is where the bulk of the damage is on the figure – I plan to paint these in a similar colour at some point (maybe even try and get some putty out and reshape the missing bits…). The centre of its chest deviates from both the original and film designs, as it has two ribs instead of one central one. Also the shoulderblades are longer and larger. We have some strange posing with the arms, but I suspect that was to simplify the moulding process for the resin, giving this alien a stylised look of its own.

Left:

image

Here we see the head is more penisy, which follows Giger’s design more than the films. The shoulders seem to be a less-shaped version of the film version. The mould is nicely detailed though, and the shading on the figure is nice. The red and silver of its lips and teeth has been nicely done. If you look near the neck, you’ll see a little of the resin has been chipped off due to the bobblehead feature. I guess this was made when bobbleheads were in! With the egg part, the veins on it have been highlighted with paint, which I like. Whilst the eggs themselves don’t have veins, they’re usually on the ground below, which I assume where the inspiration for this came from. 

Right:

image

This side has fared better, and isn’t chipped by its neck. Here we can see the alien is a bit tubby – I feel the body needs to be a bit thinner and a bit more shaped to give off a full “Alien” vibe. 

Top of head:

image

The details are nicely rendered, and feel like a simplified version of the Alien Warrior head design. 

Back:

image

Here we don’t have protrusions, which again, was likely to simplify the moulding process… or to make the mould smaller. I suspect the artist didn’t want to cast and glue/pin the extra pieces on, so they’ve come up with their own back design. which works decently well. With Giger’s originals, they did (tend) have protrusions, but from lower down and flatter on the back. Again, the tail is flattened against the body to make it an easier mould to deal with. 

Inside the ‘egg’:

image

I like the way the tail curls around and sits in the bottom of the egg. We have some liquid detail in the egg, which I like. 

Bottom:

image

Apparently there are 1199 others out there… do you own one? Know anything about this? If so, please comment below! Water is from rinsing the dust off this fellah – he was very dusty when I got him and in need of a clean. 

Overall, I like this unusual piece – I feel it’s a more “inspired by” piece, as it doesn’t follow one particular Alien design, as far as I can tell. There are shortcuts the artist has taken to make it easier to cast, but overall, these mostly work, and make it its own piece. Don’t think I’ll get much use of the bobblehead functionality though, lol. 

(Also what’s it with amateur artists not signing their stuff?)